Great for use anywhere, this dimmable 24v 14.4w/m single colour LED strip light can help you save a huge amount on your lighting bills or add great effect lighting wherever you need it.
As with all of our LED strip lights, it comes with a self adhesive backing, allowing for installation in nearly any location. Due to the wide range of surfaces that the LED Strip Lights are stuck to, we unfortunately cannot guarantee the adhesive on all surfaces. These strips can also be cut to every 100mm making custom lengths of strip very easy to make up.
Did you know that all of our LED Tape is dimmable? Simply use alongside a dimmable driver to alter the brightness!
You can also benefit from the variety of discount codes that are ran frequently on the site. These discounts can save you up 20% on your whole order.
Please be informed that any and all IP65/67 LED Tape will be supplied to each customer in 5m reels.
For example, if you were to order 7m of tape - it will come to you, ready-soldered, in a reel of 5m with an attached 2m of tape.
Find further information on Strip Lights on our FAQs page.
Water Protection & Colour Options
LED strip lights have a few factors for consideration when installing them, mainly the colour of the LEDs and the waterproofing.
Warm white is what replicates traditional halogen lights closer than any other colour. Warm white provides the soft white colour that traditional light fittings emit. This is recommended for use in living areas such as dining rooms and living rooms. Warm white is also used a lot in bedrooms and hallways due to the colour that it emits. If the room you're looking at installing the strips lights into has a more traditional styling to it then warm white is, again, recommended over cool white.
Unlike warm white, cool white is a cooler, clearer white. It has more use in rooms that require as much light as possible such as bathrooms due to its cooler colour. Modernly design rooms and houses are also recommended to have cool white due to its colouring.
Both of these colours are also available in different IP Ratings to add to the range of uses. Both are available in IP20 and IP65 ratings for full internal use.
■ IP20 Rated LED strips have no protection against water and need to be installed where water cannot reach the strip lights.
■ IP65 Rated strip lights come with a layer of silicone on them to protect them from splashes and jets of water. They are generally installed in bathrooms to combat the steam and water as well as externally where water access is very limited.
As all IP Ratings of LED strip have a varying level of silicone on them, they come in different maximum lengths. IP20 is available in a max length of 10m whereas IP65 is available in lengths of up to 5m. All LED Tape is charged by the metre though - when filling out the quantity box at the top of the page, please round up to the nearest metre.
Customer Cutting Service
As mentioned previously these strips can be cut every 100mm. We are aware that not everyone has the option to cut and solder LED strip lights. In light of this, we offer a cutting soldering service! The first 3 are free, then every subsequent will be charged depending on the type of tape you have.
On top of this, we can also extend the cable on the end of the strip lights with 2 Core Cable to as long as you need.
All LED Tape is priced per metre. If you purchase any amount of LED strip lights then we will send it out as one full, uninterrupted length e.g. 1 x 3m rather than 3 x 1m.
Illuminating Your LED Strips
This specific LED strip runs at 24v and requires a power supply for it to function. We have a range of power supplies available for use with the strips, however not all are available in 24v.
Our power supplies are also available in a range of maximum loads to accommodate for longer lengths of strip lights. The list below is of notable lengths and the minimum loads that they require:
■ 1 Metre - 14.4 Watts;
■ 3 Metres - 43.2 Watts;
■ 5 Metres - 72 Watts;
■ 10 Metres - 144 Watts.
We recommend that any power supply that is used for LED strip lights to be a minimum of 10% above the load you'll be running. This helps maximise the lifespan of the power supply by making it run at a lower temperature and operate more efficiently.
12 Volts & 24 Volts, What's The Difference?
All of our LED strip lights are low voltage and require a power supply to operate. It is a common misconception that 24 volt strip lights are actually brighter than the 12 volt ones. Whilst this is untrue, 24 volt LED strips can run up to double the length of 12 volt.
This increase in length makes 24 volt LED tape a lot more feasible for commercial installations due to the lengths that can be ran.
LED Strips That Can Last Over Two Decades!
Our LED strip lights have an estimated lifespan of up to 50,000 hours which can last up to 15 years. This lifespan can even be extended further depending on how the they are installed. The main three influences of strip lights life are documented in the table below:
LED strip lights that are stuck onto a surface which effectively dissipates heat such as aluminium.
Surfaces such as wood, that dissipates heat poorly can cause LED strip lights to have a reduced lifespan.
Using IP Ratings where only necessary.
Excessive use of IP Ratings can cause premature failure in LED strips.
A cool airflow around the strip lights helps the strips maintain their life.
A warm environment can cause the strips to have a reduced lifespan.
If all positive influences are met then you can get up to 50% extra lifespan making a 75,000 hour lifespan, or over 2 decades!
We can also help you add to life of your LED strips with surface mountable profiles. Made of aluminium, they are very effective of dissipating heat and helping extend the lifespan of these lighting solutions. The aluminium profiles also have a more cosmetic feature due to availability of frosted or clear diffusers to provide a full, complete finish.
If you have internally installed IP65 LED strip lights without profiles they are not covered by any form of warranty for heat issues. Replacements for these will be charged at 50% when bought with aluminium profiles.
Installation Guidance And Extensive Warranty Cover
LED strip lights can be cut and soldered by us, but if you would like to cut and solder the strips yourself or you are having trouble doing so, then have a look at our 'How To' video guides on our YouTube channel.
Very good and works well so long as you keep the positive side matching in all the connections. Easy to trim to the correct length and not difficult to solder the joints. The light given out was great to illuminate four levels of glass shelving within each section of a display cabinet with variable intensity via the remote controlled dimmer switch.
Very bright output and super slim construction. So easy to cut and solder.
Ensure you specify number of cut lengths you intend making as each length can be fitted with a neat ferrule arrangement. (Mine are unseen so it wasn't critical - I had less than half what I would have needed). Also, aluminium sections are mounted using supplied clips - I had to make do as not enough supplied.
Adhesive backing is very strong. Edge of LED's glow greenish yellow so I am ordering diffusers to retrofit as cast light has a green tinge on the fringes.
We used the LED Strips as back lights in an old lift car and they worked brilliantly. The team at Wholesale LED advised us very quickly what product to use and they despatched the stuff next day which we got a 9am. Fantastic service will definitely be using them again.
works really well, happy with level of brightness as recommended. top notch phone service, thanks.
If you would like to return anything you have bought from Wholesale LED Lights, you have 14 days from the date of delivery to notify us. Should you with to, you then have a further 14 days to send the item back to us. You will then receive either a refund or an exchange.
This applies to all items unless otherwise stated, for example, any custom-made items (such as cut to length LED Strip Lights, or LED Door Signs) are excluded from our 14 day returns policy.
If an item has been modified, attempted to have been repaired or otherwise tampered with, Wholesale LED Lights are not obliged to offer a refund or exchange.