In order to get the most out of your Dual Colour LED Tape, you’ll want to have a look our Dual Colour LED Controllers.
Made by industry titans Mirrorstone Lighting, they use radio frequency to operate – so you don’t need to point the remote right at the receiver, you don’t even need to be in the same room as the signal can pass through walls!
This also means you can use them from further away compared to more conventional infrared controllers – as it has a range of 20m.
The remotes themselves are entirely touch based, and allow you to switch your strips on and off, change the mode and dim them down too. You can also control the colour temperature too – switching between warm white, cool white, or even both at the same time.
One of the good things about the controllers on offer, is that they’re compatible with both 12V and 24V tape. The maximum wattage changes as a result – 144W for the 12V, and 288W for the 24V.
All of this is powered simply by a set of 3 AAA batteries.
This particular tape uses 14.4W and beams out a maximum 1020 lumens. It’ll keep going for up to 50,000 hours and is available with an optional IP65 rating, guarding it against light jets of water from any direction.
Crucially, this tape runs on 12V, which affects the length you can run from the controller. The maximum load is 144W, so you’ll be able to run up to 10 metres of dual colour tape from it.