Brilliant for use as main lighting in any room, the Mirrorstone 14.4w/m single colour LED strip light will save you in excess of 75% on your lighting bills.
Our full range of LED strip lights come with a self-adhesive back, allowing you install these nearly anywhere around your house. Due to the wide range of surfaces that the LED Strip Lights are stuck to, we unfortunately cannot guarantee the adhesive on all surfaces. Also, please note that the IP67 LED Tape does not come with the 3M Adhesive. You can also cut these strip to every 50mm making it very accurate when preparing lengths for installations.
Did you know that all of our LED Tape is dimmable? Simply use alongside a dimmable driver to alter the brightness!
Please note that all IP67 and IP68 tape comes in lengths of up to 5m max, and will not fit in any of our aluminium profiles.
IP65 tape comes in maximum lengths of up to 25m, and will be soldered tape to tape every 5m for any lengths over 5m. Although 25m lengths are available in this way, there is no guarantee that it can be ran continuously due to power drop. Please get in touch with us if you require further information about this.
IP20 tape may or may not come soldered tape to tape, as this depends on how it arrives to us from our suppliers.
Find further information on Strip Lights on our FAQs page.
The brand new Spectricline of LED strip lights will massively improve your lighting experience. These strip lights bring more vivid lighting, with a greater lumens to energy expenditure ratio than ever before. The life expectancy has been increased, with a whopping 50,000 hours of usage delivering a versatile light every single time.
Areas To Install Your LED Strips And Varying Weatherproofing Options
When installing your LED strips, there are a few factors you need to consider for the installation such as light colour and waterproofing. These options can really effect both the life of strip and the whole mood of the room.
Warm white is a colour that is closest to traditional halogen lights and provides that soft white effect. It is most recommended for use within living areas such as living rooms and dining rooms. It is also installed a lot in bedrooms and hallways due to its warmer colour. Rooms with more traditional decor also tend to have warm white installed and is generally better looking with the furniture.
Unlike warm white, cool white is a cooler, bright white. Generally it is mainly used in rooms which will require more light. It has more use in bathrooms due to its cooler colour. It is also used in rooms that have a very modern design to them to compliment the decor. Cool white is also used in offices and warehouses due to the colour it gives and is recommended there as well.
Between both colours, daylight sits as a solid middle ground due to its bright light colour whilst still remaining relatively Warm. Because of this, daylight is very versatile and usable across all installations including bedrooms, bathrooms and kitchens. It can be used in all styles of rooms but it generally suits modern styles better. Along with our 4.8w/m single colour LED strip lights, these are the only LED strip lights available in daylight.
Alongside the range of colours, there is also a variety of IP (waterproof) ratings available so you can install them nearly anywhere. The IP Ratings and the general use of them is listed in the table below:
IP20 is the least protected against any form of water and is only used for internal installations excluding the bathroom.
Strips that are IP65 rated come with a silicone coating to it and can with stand splashes and jets of water. IP65 is mainly used in bathrooms and in external installations where direct water would struggle to get to the strip.
Being fully submersible, IP68 and IP68 Nano LED Strip Lights can be installed nearly anywhere. With up to a 10m depth of submersing, this strip is installed in swimming pools and outdoor decorative features.
IP68 and IP68 Nano strips both have the same level of waterproofing, however, IP68 Nano differs in one large way. IP68 Nano comes with a hydrophobic silicone coating that makes is completely resistant to water. All our LED Tape is charged by the metre - when specifying the lengths you require, please round up to the nearest metre.
Get Bespoke Length Strip Lights With The UKs ONLY Cutting And Soldering Service
All LED Tape is priced per metre. If you purchase any amount of LED strip lights then we will send it out as one full, uninterrupted length e.g. 1 x 3m rather than 3 x 1m.
Making Your Lights Power On
Our LED strip lights come in low voltage of either 12 volt or 24 volt. These strips can be powered by any of the wide range of power supplies that are available, from AC/DC power adapters to waterproof LED driver.
Our power supplies also come in a range of sizes to accommodate for as longer lengths as possible, the below guide allows you to see the power being used on specific lengths:
■ 1 Metre - 14.4 Watts;
■ 3 Metres - 43.2 Watts;
■ 5 Metres - 72 Watts;
■ 10 Metres - 144 Watts.
When Installing any LED power supplies, we advise that the load is 10% less than the maximum load as this extends the power supplies life, helps it manage its heat better, run more efficiently.
Extending Your LED Strips Life And Providing A Cleaner Finish
Our strip lights come with a life expectancy of 50,000 which, depending on use, can last for over a 15 years! Not only is this lifespan extremely long, you can also extend it out even further.
The LED Strip Lights are stuck onto a surface which dissipates heat very effectively.
If the strips are on a surface which doesn't dissipate heat very well then its life can shorten.
If the strips are in a cool environment then the temperature of the strips will be cooler.
If it's in a warm environment the strips could fail prematurely due to overheating.
Don't use IP ratings if unnecessary.
Over use of IP rating e.g. IP67 rather than IP65.
If you meet all of the favourable conditions then you can extend the life of your LED strips by up to 50%, meaning you get a lifespan of them of up to roughly 22 years!
To help you with the extension of the life, we sell aluminium profiles to fit LED strip lights that can help dissipate the heat more efficiently than most surfaces. Aforementioned, this dissipation greatly improves the lifespan of your strip lights. The profiles are also available with the option of coming with a clear or frosted diffuser to provide a complete finish to the installation.
The previously mentioned IP65 LED strips are not covered by any warranty if they are installed internally without being mounted into aluminium profiles. If the strips are installed without the profiles and fail in some manner within the first 2 years of purchase then replacements will be charged at 50% when bought with aluminium profiles, which are charged at full price.
Guidance On Installation And Increasing Your Warranty
If you have any questions about our wholesale rates & bulk buy offers, the colour temperatures or the life of LED strips then please feel free to contact us by e-mail on firstname.lastname@example.org or by telephone on 0116 321 4120.
If you would like to return anything you have bought from Wholesale LED Lights, you have 14 days from the date of delivery to notify us. Should you with to, you then have a further 14 days to send the item back to us. You will then receive either a refund or an exchange.
This applies to all items unless otherwise stated, for example, any custom-made items (such as cut to length LED Strip Lights, or LED Door Signs) are excluded from our 14 day returns policy.
If an item has been modified, attempted to have been repaired or otherwise tampered with, Wholesale LED Lights are not obliged to offer a refund or exchange.